Quick Order C/M lights
Hot sellers:
Cargo trailer style
RV style, high visibility 14 LED
Slim/Low profile ID bars
3/4" round marker lights NEW!
LED Strobes
Slim backup light bar NEW!

Quick Order RV Lights
RV LED interior light fixtures NEW!
RV LED to replace fluorescent
RV 1141 LED 252 lumens
RV 1141 LED 300 lumens
RV 1076 dual contact base
RV T10 wedge base LED 906 style
RV T10 wedge base LED 921 style
G4 LED to replace G4 halogen
Recessed ceiling light for RVs
Chargers/Inverters and stuff:
Xantrex TrueCharge 2
Battery cutoff switch

Cab roof lights:
Chevy/GMC LED cab lights
Dodge LED cab lights
Tail Lights
Chevy/GMC 99-06 truck
Chevy 07+ truck
Chevy/GMC SUV
Dodge truck
Ford truck
Other lights:
Chevy CHMSL 99-07 07.5+
Chevy 07+ headlights NEW!
Chevy 99+ dually fender LEDs
Ford Superduty mirror LEDs
Line of Fire LED Light strip
LED Strobes
Bed rail / cargo lights

Installation accessories
BACKPACKS & Stuff
Jackstrap
4" round LED backup lamps
6" oval LED backup lamps
Tethered valve caps
1 watt, 3 LED driving lights
Mac's Custom Tiedowns
Show Schedule
Links

LED upgrade lens unit for Model 84 and 86 tail light fixture

Bargman introduced this unit as a perfect solution to upgrade your cargo trailer or RV to LED lighting with a minimal amount of hassle.

Fits your existing tail light housing without any cutting or permanent modifications. Also available as a complete tail light assembly.

Note: The LED module is about 3/16" deeper (thicker) than the original lens. Not all customers choose to order the new "enhanced height backup lens", which matches the height of the new LED lens unit, which really is only used to enhance the appearance by having the lenses all the same height/depth (thickness).

Manufactured by Barmgan, Meets DOT and FMVSS / CMVSS 108 requirements.

Features:

• Dual brightness - acts as a tail light and brake light / turn signal just like an 1157 bulb
• Brighter and more visible than traditional incandescent lights
• Employs high output, wide angle LEDs
• Fitted with wire leads that are attached to a bayonet style base that fits into the existing bulb socket for true "no hassle" installation

Simply put, incandescent bulbs produce more-or-less full spectrum light (and a lot of heat) and filter out everything but red light through a colored lens. LEDs, on the other hand, produce a saturated, wavelength-specific light—in this case deep, intense red—without any heat or wasted light energy. This is why LEDs require far less power to produce light of equal brightness.

The installation process is quite simple: Remove two screws for the lens, remove the existing bulb, fit the module's adapter into the bulb socket just as if you were installing an incandescent bulb, fit the lens module in place and replace the screws!